HF Radio Amplifier with Lowpass/Bandpass Filter
This page introduces the Enclosure of the Amplifier.

Squawker Talker Main Box Design

Prototype Filter Box



The Faraday Tape used to shield the Band Pass and Low Pass filter circuits from EMI and RF Interference


The Laser Cut Pattern Design produced to created the Isolation Box for the Low pass Filter (Left) and the Band Pass Filter (right), cut from Black Acrylic Plastic


Laser Cut Video
Laser Cut

The Heating and Enclosure Mounting Design, with the top view (top) showing the position of the Heatsink Mounting Bracket relative to the enclosure walls, and the side view (bottom) showing how this Bracket is used to mount the Heat Sink and TPU Foot to the enclosure.


The 3D printed Spacers designed to enable the PCB boards to be mounted to the enclosure. Each has an Inner Diameter of 3mm, an Outer Diameter of 4mm the Lengths include 3mm, 6mm and 12mm.

The 3D printed bracket designed to mount the TPU Feet and Heatsink to the enclosure.

The Enclosure Foot printed from TPU.
