top of page

Project Overview

In recent BC history, forest fires within have ravaged rural communities. During these natural disasters, communication blackouts occur due to failure in the power grid and cellular networks. HF radio offers the potential for decentralized emergency communications, but affordable HF radios are low power, thereby limiting adoption. This project was conducted to create a portable HF amplifier designed to pair with low power, affordable transceivers to facilitate long range emergency communications.

 

To initiate this project, several current market amplifier offerings were analyzed, looking at the strengths and weaknesses of each to determine gaps in the market. After referencing these competitive offerings, the feature set of the amplifier was specified. The amplifier would need to offer high gain, run on 13.6 V power, have cooling features, in addition to being lightweight and affordable. The amplifier would have a manual bypass switch and mode select between AM and SSB. A 1.8 – 30 MHz bandpass filter was specified to be placed at the input of the amplifier, in order to filter out band noise prior to amplification. A 30 MHz lowpass filter was placed at the output of the amplifier, to remove any unwanted harmonics.

 

To design this amplifier, an in-depth literature review was completed, obtaining critical knowledge on amplifier circuits and filter layouts. From this research, the Motorola EB63 linear amplifier was selected as the base circuit of choice for the amplifier, offering a high gain output of 140 W-150 W. This circuit was modified to include mode selection and manual bypass features, as well as replacing obsolete components with modern alternatives. A pi-network constant k bandpass 1.8 – 30 MHz band pass filter was designed and simulated in LTSpice, along with a 30 MHz 9th order T based Chebyshev filter. Other circuits, including a voltage regulator, mode select, and fuse circuit were also designed, with PCB schematics for all of the above circuits being created. Components were ordered, and a suitable enclosure using an extruded aluminum heatsink and laser cut/3D printed components were designed and produced.

 

The amplifier was assembled, first winding the LPF inductors using a custom tool, before soldering PCBs, assembling the filters, tapping the heatsink, and assembling the complete prototype. Each component of the prototype was fully tested, with the frequency response of the forward voltage gain for the BPF and LPF being measured, and observed, with filter layout being adjusted to achieve optimal performance, with minimum passband ripple and strong attenuation outside of the passband. The amplifier circuit’s gain was tested, noted to be linear in nature, with only minor fluctuations due to transceiver related power output inconsistency. The specifications of the amplifier were almost all met or exceeded, with only the unit cost being above the specified $600.00 limit, and the amplifier volume being larger than the initial volume goal. The amplifier was field tested, demonstrating the potential for HF to be used as a portable, rapidly deployable emergency communication system.

 

In conclusion, Group 4 successfully designed a high gain, portable amplifier with input and output filtration for use in emergency communication. To complete this report, future development recommendations were included, from suggesting integrating an SWR/power meter, antenna tuner, and conducting additional tests on other HF bands.

Screenshot 2025-07-04 112045.png
bottom of page